AxWare
Autocross timing with AxWare: live run feed through Monitor output, plus run exports with PAX and cone penalties.
AxWare is widely used for autocross and solo events. It emits the same RMonitor record set as MyLaps systems, so the timing bridge works unchanged.
Live
-
Enable Monitor output.
In AxWare, open Setup → Network and enable Monitor output. The default port is
50000. -
Run the bridge:
node bridge.mjs --event <eventId> --key <outlapApiKey> --host 127.0.0.1 --port 50000 --vendor axware -
Check the feed in Race Control.
File import and cone penalties
AxWare run exports are recognised by their Raw, PAX and Cones columns (or pylons). When you import one, cone penalties are applied to the run time for you. Columns for off-course, DNF and similar markers are mapped to invalid runs.
See File import for the full list of recognised columns.
Was this page helpful?
Reviewed · Contact support